NAD Electronics L 76 User Manual download pdf (Page 8)

ENGLISH FRANÇAIS

DEUTSCH

NEDERLANDS

ESPAÑOL

ITALIANO

PORTUGUÊS

SVENSKA

CONNECTING AUDIO EQUIPMENT

CAUTION

• Do not plug the power cord of any component into AC outlets and do not turn their POWER switches

on until all connections have been performed.

• The cable connectors should be fully inserted into the jacks. Loose connections may cause hum and

noise.

• Read the instructions for each component you intend to use with the receiver.

AUDIO SIGNAL JACKS

AUX IN jacks Connect the Auxiliary output jacks to the AUX IN jacks.

TAPE (IN/OUT) jacks

• Connect the TAPE jacks to the cassette deck.

• Connect the cassette deck output (LINE OUT)jacks to the IN jacks.

• Connect the cassette deck output (LINE IN)jacks to the OUT jacks.

AUDIO CONNECTION CORDS

To make these connections, use interconnect cords with RCA plugs. Make sure that you connect the white

pin-plug to the white jacks (left) and the red pin-plug to the red jacks (right).

CONNECTING THE PRE OUT JACKS

Since subwoofer signals are not amplified, use a subwoofer with a built-in amplifier or connect it to the

amplifier connected to this unit.

NOTE

• If a speaker is connected directly to the PRE OUT jack without an amplifier connected, no sound comes

from the speaker.

CONNECTING THE AC POWER

Be sure to connect the power cord to an AC outlet which supplies the correct voltage.

• Hold the power plug when plugging or unplugging the power cord.

White

L L

R R

White

Red

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

NAD Electronics L 76 User Manual Page 8