NAD Electronics L75 User Manual download pdf (Page 7)

CONNECTING ANTENNAS

AM INDOOR LOOP ANTENNA

The high-performance AM loop antenna provided with the receiver is sufficient for good reception in most

areas. Connect the loop antenna’s wires to the AM antenna terminals as shown.

Place the antenna on a shelf, for example, or hang it on a window frame, etc., in the direction which gives

the best reception, as far away as possible from the entire system, speaker cords and the power cord, to

prevent unwanted noise.

AM OUTDOOR ANTENNA

If the AM loop antenna provided does not deliver sufficient reception (because you are too far from the

transmitter or in a concrete building, etc.), it may be necessary to use an outdoor AM antenna.

Use an insulated wire more than 15 ft (5 m) long, strip one end, and connect this to the terminal as shown.

The antenna wire should be strung outdoors or indoors near a window.

For better reception, connect the GND terminal to a reliable ground.

NOTE

Even when using an outdoor AM antenna, do not disconnect the AM loop antenna.

AM Loop Antenna (provided)

CAUTION

To avoid damage the speakers by inputting a sudden high-level signal, be sure to switch the power off

before connecting the speakers.

Connect the cable from each speaker to the corresponding terminal on the rear of the receiver.

• Most speaker cables have different markings, textures or colors to help you tell the difference between

negative and positive.

• Be sure to connect the positive (+) terminal on each speaker to the positive (+) terminal on the receiver.

Similarly, connect the negative (-) terminal on the speaker to negative (-) terminal on the receiver.

NOTES

• Use speakers with a nominal impedance of 8 ohms or more.

HOW TO CONNECT

1 Strip back the cable covering by about 1 cm and twist the wire strands together.

2 Turn the terminal cap counterclockwise to loosen it. The speaker terminal caps cannot be fully removed

from the base.

3 Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it.

4 Make sure it is fastened firm by pulling the cable lightly.

CONNECTING SPEAKER SYSTEMS

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

No comments

NAD Electronics L75 User Manual Page 7