NAD Electronics Silver S100 User Manual download pdf (Page 7)

TROUBLESHOOTING

NO SOUND • Power Mains cable unplugged or power

not switched on

• TAPE 1 MONITOR selected

• Mute on

• Connector to power amp not fitted correctly

• Internal fuse blown

• Power amp or active speaker

not switched on

• Check if AC Mains cable is plugged in and

power switched on

• De-select monitor mode

• Switch off Mute

• Check connections

• Consult dealer

• Switch power On

Problem Cause Solution

NO SOUND IN ONE CHANNEL

• Connector to power amp not fitted correctly

• Input lead disconnected or damaged

• Check connections

• Check leads and connections

PROBLEM ON PHONO INPUT ONLY • No signal

• Hum on Phono input

• Weak or Distorted signal

• No phono amplification module installed

• Check MM, MC switch set correctly

Check phono earth lead is connected

• Check the turntable is connected to the

correct MM or MC phono input

REMOTE CONTROL NOT WORKING • Batteries flat, or incorrectly inserted

• IR transmitter or receiver windows

obstructed

• Check or replace batteries

• Remove obstruction

WEAK BASS / POOR STEREO IMAGE • Speakers connected to the power

amplifier wired out of phase

• Check connections to all speakers in the

system

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

NAD Electronics Silver S100 User Manual Page 7