NAD Electronics L70 User Manual download pdf (Page 29)

LOADING CODE-LIBRARIES

The HTR L70 can store a different library of default NAD codes for each of its Device Selector “pages.” If

the original default library does not control your NAD CD player, tape deck, DVD player, or other

component, follow the procedure below to change the code-library.

Begin by ensuring that the component you wish the HTR L70 to control is plugged in and powered-up

(“on,” not merely in standby). To enter the HTR L70’s Library Mode, simultaneously press-and-hold for 3

seconds both the desired Device Selector key and the “PROGRAM” key, until the Learn LED turns green.

While keeping the HTR L70 pointed toward the component, enter the first appropriate three-digit code-

library number from the table below. If the component turns off, press “ENTER” to accept that code-

library number and exit the Library Mode. If the component does not turn off, enter the next three-digit

code-library number from the table. When you enter the correct number the component will turn off;

press “ENTER” to accept that code-library number and exit the Library Mode.

NAD-brand component HTR L70 code-library numbers

CD Player (new) 200

CD Player (old) 201

DVD T562 600

DVD T550, L55 601

DVD T531, T571 602

DVD T512, T532, T572 602

SEARCH MODE

If none of the codes from the table turn off the component, and if you are quite sure you have followed

the above procedure completely and carefully, you may want to try the “search” method as follows:

Enter Library Mode by simultaneously pressing-and-holding for 3 seconds both the desired Device Selector

key and the “PROGRAM” key, until the Learn LED turns green. Now press-and-hold the HTR L70’s

or key; the remote will step through all the available codes at a rate of approximately 1 per second.

When the component turns off, immediately release the cursor key; press “ENTER” to accept that code-

library and exit the Library Mode. Try a few commands; should you prove to have stepped past the needed

code-library, re-enter the Library Mode and use the cursor key to step back to it.

NOTE

It is possible that search mode will find code-libraries that operate, at least partially, some other-brand

(non-NAD) components. You may certainly exploit such capabilities as you find them. However, since

we can only ensure the completeness or accuracy of NAD code-libraries, we cannot support the HTR

L70’s operation with other-brand components.

USING THE HTR L70 REMOTE CONTROL

Operation

ENGLISH

FRANÇAISDEUTSCHNEDERLANDSESPAÑOL

ITALIANO

PORTUGUÊS

SVENSKA

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

No comments

NAD Electronics L70 User Manual Page 29